Long Pulse 5000 W Noncontaminating Water-Cooled Thermopile Sensor with Ø50 mm Aperture
Long Pulse 5000 W Noncontaminating Water-Cooled Thermopile Sensor with Ø50 mm Aperture
The 5000WP-LP2-50 thermopile sensor is a water cooled thermal laser power sensor for high power density and long pulse lasers. It has a 50 mm aperture and can measure optical power from 20 to 5000 W. Its high damage threshold LP2 coating covers the spectral range 350 to 2200 nm. This sensor is specially designed for noncontaminating water flow.
- Long pulse 350-2200 nm absorber
- Water-cooled for 20 to 5000 W average power measurement
- Specially designed for noncontaminating water flow See All Features
Features
LP2 Sensors Coating With Very High Damage Threshold and Very Low Reflection
Even higher damage threshold…flat spectral response…absorption up to 96%... These are some of the characteristics of the new “LP2” type laser power sensors from Ophir.
Water Cooled Sensors: Things to Look Out For
Water cooled sensors are commonly used when measuring laser beams of more than a few hundred watts. In this video, you will learn about some critical issues you need to consider when using water cooling, such as water temperature, water flow rate, and corrosion prevention.
Choosing a Thermal Sensor
In this short “Basics” video we review the use – and selection - of thermal sensors for measuring low, medium and high laser powers.
Sensors for Measuring Laser Power
In this short "Basics" video we review in general how one goes about measuring laser beam power, so that you'll have a clear understanding of what the different sensor types are, and when to use each type.
Thermal Power Sensor Accuracy
Ophir former CTO Dr. Ephraim Greenfield discusses the various factors that contribute to uncertainties in measurement when using Ophir laser power and energy meters.
Effects of Incidence Angle on Measurements
In this video, you will learn to what degree a beam’s incidence angle matters, and for which sensor types this should be taken into account.
Thermal Sensor Calibration
As the spectral sensitivity of the absorber used for the power and energy measurement is not fully linear, Ophir sensors get a high precision calibration by default with more than one wavelength.
Each thermal sensor is calibrated independently of a particular Ophir power meter with its calibration information contained in the DB15 plug. When the sensor is connected to the meter, the meter reads and interprets this information to display a calibrated reading. Each power meter is calibrated independently and has the same sensitivity as an other meter within about 2 tenths of a percent.
Unless otherwise indicated, Ophir sensors and meters should be recalibrated within 18 months after initial purchase, and then once a year after that.
Accessories
5000W / 10K-W / 15K-W Protective Housing
10K-W Protective Cover for Water Cooled Sensors
Metric Water Fitting
Thermal Sensor Cables
Sensor Connector to BNC Adapter
Resources
Data Sheets
Catalogs
Power Sensors Catalog(11.2 MB, PDF) Laser Power & Energy Measurement and Laser Beam Analysis Catalog(27.5 MB, PDF)
Drawings & CAD
5000WP-LP2-50 Drawing(315.6 kB, PDF)
Technical Notes
Absorption, Angle Dependence and Damage Graphs for Thermal Sensors(216.1 kB, PDF) How to Use Water Cooled Ophir Sensors 5 Situations Where Laser Performance Measurement is Necessary How do I know what range, or scale, to set my power/energy meter to?
Technical Articles
Ophir Power/Energy Meter Calibration Procedure and Traceability/Error Analysis Laser Measurements in Materials Processing
